Peugeot 308 Key Fob Replacement
Peugeot's 308 might seem slightly old, but it is still attractive. It's not the most luxurious car in its class, but it's an enjoyable and relaxing drive.
We are often asked at Coded Car Keys to replace peugeot key fobs. No matter if the issue is constant or intermittent the following suggestions should assist.
Water Damage
If you accidentally drop your fob in the midst of a puddle or splash it with water while swimming, kayaking, canoeing, rafting, or canyoning, it's likely to be damaged by water. The best way to stop this from happening is to keep it in a dry, dry bag when you're outside or performing activities where the fob could be exposed to a lot of water.
You should also make sure that the fob is completely dry prior to opening it and re-using it. If you detect any smells coming from the fob, like an industrial-like liquid smell or windshield washer fluid, it's another sign that it's submerged in water.
A wet circuit may cause the battery's charge to be drained or even explode. If you can get the 308 keyfob from the water it is best to turn the button side up and shake as much water as you can prior to opening the casing. Remove the battery, then wipe the circuit board clean using a cotton swab that is dipped in 90 percent alcohol.
Other reasons that your Peugeot 308 remote entry keyless system may not function include a dead battery in the coin-cell or receiver module issues signal interference or a malfunctioning chip. If none of these are the problem you can reset the system by disconnecting a 12 volt battery from the car for 15 minutes.
Dead Coin Battery
Peugeot cars are equipped with a remote start system that allows the driver to start the car from afar, warming up or cooling down the car prior to entering. This feature is extremely useful particularly in cold winter months. But sometimes, the remote stop system stops functioning due to a variety of causes, such as a dead coin battery.
A coin-shaped battery that is found inside the key fob has a lifespan of two to four years, based on how often it is used and the location where it was purchased. The date for use-by will be displayed on the packaging or in the user manual.
If the key fob has stopped working after exposure to water that is clean and you want to remove the battery, clean the electronic chip using a paper towel and isopropyl alcohol, and then dry it completely before replacing it. In the event of exposure to salty or soapy water, the chip could be damaged and you'll have to replace the key fob completely.
If you're unsure whether the battery is in good condition You can test the voltage using a multimeter that is connected to both the minus and plus terminals. The voltage should be between 12-13 volts but if it's lower, the battery should be replaced. You can also reset your onboard computer by disconnecting and reconnecting the 12 volt batteries in reverse order. (positive cable first, then negative cable). The engine should start.
Faulty Receiver Module
If you don't get the "Key Detected", it could be that your receiver module is malfunctioning. It's the component that sends out the signal when your key fob is activated. It also acts as an alarm that stops the car from starting if it doesn't have the correct key.
The cause could be a number of factors, including water damage or just getting old. If your Peugeot 308 key fob has been exposed dirty tap water, for example, the electronic chip inside the device will be damaged. In this case it is necessary to take the device apart and clean it thoroughly using isopropyl alcohol, or electronic cleaner. Once the battery has dried, you can try again.
If the problem persists it is recommended to consult the local Peugeot expert or locksmith. They can utilize the diagnostic tool to pinpoint the issue and fix it.
It is stressful to lose your Peugeot car key. However, a qualified auto locksmith can resolve the issue in just a few minutes. They can cut a new key and programme it to your vehicle, so you're back to the road as quickly as possible. Find a locksmith in your area.
Faulty Electronic Chip
The chip inside the Peugeot 308 key fob is an vital component of the remote control system. If it becomes damaged, your car might not start or you might get a message saying "anti-theft active". In this scenario the only option is to replace the key. Professional auto locksmiths are able to provide the service within the shortest possible time.
The chip in your Peugeot 308 key fob can fail due to sweat, water damage dirt, or any other cause. If your Peugeot key fob has been exposed soapy or dirty water, it needs to be cleaned right away. You can wipe the electronic component using the help of a towel that is soaked in isopropyl Alcohol. The battery should be allowed to dry completely.
Sometimes, peugeot car key replacement can stop working because of radio interference. This can be caused by other devices that operate at the same frequency as your Peugeot key fob. This can be caused by poor conditions or objects close to the vehicle. It is recommended to visit a Peugeot dealer if you experience this problem.
The Peugeot Key Fob 207/308 is very delicate and requires special care. It is crucial not to throw or drop the key fob. If you lose something, try to find it as soon as you are able to. You can reset your on-board computer by disconnecting the battery for a few minutes. Remove the negative cable before the positive.